Submission Preparation Checklist
As part of the submission process, authors are required to check off their submission's compliance with all of the following items, and submissions may be returned to authors that do not adhere to these guidelines.
- The submission has not been previously published, nor is it before another journal for consideration (or an explanation has been provided in Comments to the Editor).
- The submission file is in OpenOffice, Microsoft Word, or RTF document file format.
- Where available, URLs for the references have been provided.
- The text is single-spaced; uses a 12-point font; employs italics, rather than underlining (except with URL addresses); and all illustrations, figures, and tables are placed within the text at the appropriate points, rather than at the end.
- The text adheres to the stylistic and bibliographic requirements outlined in the Author Guidelines.
All papers submitted to the journal should be written in good English. Authors for whom English is not their native language are encouraged to have their paper checked before submission for grammar and clarity. The work should not have been published or submitted for publication elsewhere. The official language of the manuscript to be published in Green Technolgy is English.
1. General Author Guidelines
All manuscripts must be submitted to Green Technology Editorial Office by Online Submission at E-Journal portal address: http://greentech.uin-malang.ac.idwhere author register as Author and/or offered as Reviewer by online. If authors have any problems on the online submission, please contact Editorial Office at the following email: firstname.lastname@example.org
2. Paper Template
All paper should be prepared according to the following author guidelines in the MS Word articletemplate: https://drive.google.com/file/d/0B-qL0h1JRT4kd2lyLUdKZkV4Vnc
3. Reviewing of Papers
If the content and format of the submitted essay is seen as appropriate by the editors, the paper will then be sent out for 'blind review' by two independent referees. Revisions may be required in the light of referees' comments before a decision is made to accept or reject the paper.
4. Revision of Papers
All paper sent back to the authors for revision should be returned to the editor without delay. Revised articles can be sent to editorial office through the Online Submission Interface. The revised manuscripts returned later than three months will be considered as new submissions.
5. Editorial Office of Green Technology
All correspondences should be sent to the following Editorial Office:
Editorial Office of Green Technology
Department of Mathematic
Faculty of Science and Technology
UIN Maulana Malik Ibrahim Malang
Jalan Gajayana 50 Malang, Jawa Timur, Indonesia 65144
6. Guideline for Online Submission
Author should first register as Author and/or is offered as Reviewer through the following address: http://greentech.uin-malang.ac.id/index.php/greentech/index/pages/view/authors_guidelines
Author should fulfil the form as detail as possible where the star marked form must be entered. After all form textbox was filled, Author clicks on “Register” button to proceed the registration. Therefore, Author is brought to online author submission interface where Author should click on “New Submission”. In the Start a New Submission section, click on “’Click Here’: to go to step one of the five-step submission process”. The following are five steps in online submission process:
- Step 1 - Starting the Submission: Select the appropriate section of journal, i.e. Original Research Articles, Review Article, or Short Communication. Thus, author must check-mark on the submission checklists. Author may type or copy-paste Covering Letter in Letter to Editor.
- Step 2 – Uploading the Submission: To upload a paper to this journal, click Browse on the Upload submission file item and choose the manuscript document file (.doc/.docx) to be submitted, then click "Upload" button until the file has been uploaded.
- Step 3 – Entering Submission’s Metadata: In this step, detail authors metadata should be entered including marked corresponding author. After that, paper title and abstract must be uploaded by copying the text and paste in the textbox including keywords.
- Step 4 – Uploading Supplementary Files: Supplementary file should be uploaded including Covering/Submission Letter, and Signed Copyright Transfer Agreement Form. Therefore, click on Browse button, choose the files, and then click on Upload button.
- Step 5 – Confirming the Submission: Author should final check the uploaded manuscript documents in this step. To submit the paper to Green Tehnology, click Finish Submission button after the documents is true. The corresponding author or the principal contact will receive an acknowledgement by email and will be able to view the submission’s progress through the editorial process by logging in to the journal web address site.
After this submission, Authors who submit the paper will get a confirmation email about the submission. Therefore, Authors are able to track their submission status at anytime by logging in to the online submission interface. The submission tracking includes status of manuscript review and editorial process.
7. Preparation Guideline of texts
7.1. General Organization of Paper
The paper will be published in Proceeding at Green Technology after peer-reviewed process and decided “Accepted” by Editor. The final paper layout will be reproduced by Editorial Office Green Technogy. The final paper layout in PDF type, known as “Uncorrected Proof” should be corrected by Author. The final corrected proof will be published first in “Article In Press” pre-issue.
Paper document submitted to this journal (in one MS Word or PDF file) should be arranged as follow:
- Bodytext of paper article
- Figure Captions and Table Captions
All illustrations of any kind must be submitted as sequentially numbered figures, one to a page. Although high-resolution images are not required for the initial refereeing stage, if the essay is subsequently selected for publication then all figures and tables will need to be provided at the highest quality in digital format. When symbols, arrows, numbers or letters are used to identify parts of illustrations they must be clearly identified by a key in the figure legend, rather than in the figure itself. Similarly, internal scales, staining or processing of the figure must be explained where appropriate. Figure legends should be listed sequentially on a separate page. In all cases where the author is not the owner of the copyright of the figures, written permission must be obtained from the copyright holder(s) to reproduce the figures in this journal.
Each table must be typed, and consecutively numbered. They should have a brief informative title placed as a heading. Tables should be understable without reference to the text, but they should be referred to in the text. Explanatory caption should be brief and placed beneath the table. Please note that numbering of tables should be differ from the numbering of figures.
Paper content should, in general, be organized in the following order: Title; Authors Name; Authors Affiliation; Abstract; Keywords; Introduction;Method (for research based articles);Content/Results and Discussion; Conclusions; and References.
7.2. Paper Tittle
This is your opportunity to attract the reader’s attention. Remember that readers are the potential authors who will cite your article. Identify the main issue of the paper. Begin with the subject of the paper. Do not contain infrequently-used abbreviations.
The title of the paper must be concise,spesific, informative, and complete, not exceed 10 words (Times New Roman 16 pt, bold and centred)
7.3. Authors Name and Affiliations
Write Author(s) names without title and professional positions such as Prof, Dr, Production Manager, etc. Do not abbreviate your last/family name. Always give your First and Last names (Full Name). Write clear affiliation of all Authors. Affiliation includes: name of department/unit, (faculty), name of university, address, country, include email address. Author names should be in Times New Roman 10 pt bold and centred. Author affiliations should be in Times New Roman 9 pt bold and centred.
7.4. Abstract and Index Terms
Abstract should stand alone, means that no citation in abstract. Consider it the advertisement of your article. Abstract should tell the prospective reader what you did and highlight the key findings. Avoid using technical jargon and uncommon abbreviations. You must be accurate, brief, clear and specific. Use words which reflect the precise meaning, Abstract should be precise and honest, summarising the significant points of the paper.Please follow word limitations (200 words) and should be inTimes New Roman 9pt right and left justified.
In Introduction, Authors should state the objectives of the work at the end of introduction section. Before the objective, Authors should provide an adequate background, and very short literature survey in order to record the existing solutions/method, to show which is the best of previous researches, to show the main limitation of the previous researches, to show what do you hope to achieve (to solve the limitation), and to show the scientific merit or novelties of the paper. Avoid a detailed literature survey or a summary of the results. The introduction should clearly state the purpose of the paper. It should include key references to appropriate work but should not be an historical or literature review.
7.6. Method (for research based articles)
The methods section describes the rationale for the application of spesific procedures or techniques used to identify, select, and analyze information applied to understanding the research problem, thereby, allowing the reader to critically evaluate a study’s overall validity and reliability.
7.7. Content /Result and Discussion
Content is the body of paper, consits of sub title that representing discussion of the paper. Results should be clear and concise. The results should summarize (scientific) findings rather than providing data in great detail. The discussion should explore the significance of the results of the work, not repeat them. A combined Results and Discussion section is often appropriate. Avoid extensive citations and discussion of published literature.
In discussion, it is the most important section of your article. Here you get the chance to sell your data. Make the discussion corresponding to the results, but do not reiterate the results. Often should begin with a brief summary of the main scientific findings (not experimental results). The following components should be covered in discussion: How do your results relate to the original question or objectives outlined in the Introduction section (what)? Do you provide interpretation scientifically for each of your results or findings presented (why)? Are your results consistent with what other investigators have reported (what else)?
Conclusions should answer the objectives of research. Tells how your work advances the field from the present state of knowledge. Without clear Conclusions, reviewers and readers will find it difficult to judge the work, and whether or not it merits publication in the journal. Do not repeat the Abstract, or just list experimental results. Provide a clear scientific justification for your work, and indicate possible applications and extensions. You should also suggest future experiments and/or point out those that are underway.
Where explanatory notes and references are relevant, they should be indicated in the text by a superscript number like this . A full list of all notes and references should be provided at the end of the paper. The written of the journal references use IEEE format. Please use a reference software like Zotero,Mendeley, etc to make the citation work easier. Journal references should include all authors' names and initials, year of publication, title of paper, journal titles in full, volume number and first and last page numbers. References to books should include their edition, and all editor(s) and all relevant authors, publisher and place of publication. Online articles follow the same guidelines for printed articles. Include all information the online host makes available, including an issue number in parentheses. It is the authors' responsibility to check the accuracy of references.Examples:
 C.H. Lee, Mining general temporal association rules for items with different exhibition periods, in: The Third IEEE International Conference on Data Mining, 2002
 A. Rajak, "Modeling clinical database using time series based temporal mining" Int. J. Comput. Theory Eng., 2 (2) (2010), pp. 1793–8201
 J.Fernández, Mastering Concurrency Programming with Java 8 .Packt Publishing, 2012
 Stockhausen L, Turale S. An explorative study of Australian nursing scholars and contemporary scholarship. J Nurs Scholarsh [Internet]. 2011 Mar [cited 2013 Feb 19];43(1):89-96. Available from: http://search.proquest.com.ezproxy.lib.monash.edu.au/docview/858241255?accountid=12528
Use only recommended SI units. Numerals should be used for all numbers of two or more digits, and for single digits when attached to units of measure. Abbreviations should be defined in parentheses after their first mention in the text in accordance with internationally agreed rules.
It is a condition of publication that authors assign copyright or licence the publication rights in their articles to Green Technology. Authors are themselves responsible for obtaining permission to reproduce copyright material from other sources.